It works with led lighting with 0 10v dimming.
0 10v dimming cable.
A typical 0 10v wiring diagram is shown below.
It is the default.
0 10v control is compatible only operating from direct ac line voltage.
A 0 10v dimmer is considered analog dimming and all usai 0 10v dimming options are considered to be sink type dimming.
Control systems and lighting cable belden offers standard cables and custom combinations designed for use in a wide range of av and control applications such as lutron crestron and amx.
Our standard 0 10v dimming driver option is often provided standard check spec sheets and dims down to 10 at minimum light level.
These specialized products are optimized for all aspects of building management including the monitoring of advanced control systems and the management of.
If class 1 is desired then actions should be taken to reduce the length of the 0 10v wires.
I keep seeing advice to not run the control wires and line voltage wires in the same conduit class 1 style so i d like to run them separately class 2.
Wiring details class 2 preferred method.
This cable is constructed with 12 awg cu type thhn thwn power and ground conductors along with a control conductor assembly composed of a 30 mil pvc jacket covering two 16 awg cu type tfn control conductors.
Required for use with 0 10v dimming control for valto 400e or 600.
The phase conductors ground and control conductor assembly are cabled together and a.
With 0 10v dimming and automation installations increasing so does the need for products that both save time and make the contractor s job easier the dimming signal input to the led driver is typically supplied through a purple wire 10vdc and a gray wire signal common.
Run as class 2.
A cable with the mating connector can be purchased separately.
The unit will dim to 5 power level at 0 5v value before turning itself completely off.
The dimmers have both 0 10v dimming wires and line voltage switch leg wires.
The dimming performance of 0 10v can be impaired if the system is wired in a class 1 configuration especially if long distances of line voltage wiring are used.